Getting Set Back Up

I just got the Xi3 back.

Took it out of the box and connected it at my office.
Powered up the AP... opened the App on my phone.
Didn't connect to xclaim-setup... Hit the drop down on my phone and connected to xclaim-setup.
Reopened App.
Enter in the password from the last time I had an AP here.
Just Spins.
Power cycled and waited for the unit to come back up.
Opened up putty and connected to the device via IP.
log in root
get version
Try the App again.
"**** this App crap! They gave me a GUI a few releases ago!"
Open Browser and enter https://IPaddressofAP
Gui pops up and enter in
Familiar GUI comes back.
2.4 --- Configuration --- Wireless 1
Change the SSID and Password and select enable.
My SSID shows up and all my devices in the office connect.
Repeat for 5Ghz
Go back to 2.4 and set the channel to 1.
Click on xclaim-setup and notice that it has shut itself off. SWEET!!!
Click on Device and change the password to the password I have stored in the App on my phone.
Reopen App on my phone.
Asks for password... then just reads loading.

More testing to come.


  • vybhavramvybhavram Xpert, Moderator Posts: 1,063

    Hello @Springs ,

    Thanks for the update. Glad to know the AP reached you.

    Regarding XClaim, once connected to the new WLAN, were you able to discover the APs after your update here?


  • SpringsSprings Member Posts: 114

    "My SSID shows up and all my devices in the office connect."
    That meant that my phone connected to the SSID too.
    So opening the App on my phone...
    Enter Password
    I have to keep taping the phone to keep the screen awake. But it never connects. Or my phone rings.

  • vybhavramvybhavram Xpert, Moderator Posts: 1,063
    edited April 2015

    @Springs . Sorry to hear that. Can you try and re-install Harmony on your phone and try the same?


  • SpringsSprings Member Posts: 114
    Yup. It's the App that dies on me.
    Harmony on Samsung Note 3

    Ran wizard.
    Now the App is actually gets past asking for password.
  • SpringsSprings Member Posts: 114

    So app starts and can find the AP. But can't actually talk to it. Once you select the AP... App just spins.

    If not for the Web interface...

  • vybhavramvybhavram Xpert, Moderator Posts: 1,063

    Sorry to hear about that. Does restarting the APP help? I believe this is an AP that is already configured, correct? Are you connecting to the AP via an Open or a Secure WLAN?

  • SpringsSprings Member Posts: 114
    edited April 2015

    Hard reset WAP.
    Connected Phone to xclaim-setup
    Opened App
    Entered Password
    App Found AP
    Set up 2 SSIDs
    AP "blinked".
    Phone reconnected to SSID.
    Now the App just spins after the password is entered.

Sign In or Register to comment.